What code is P1345?
Error Code P1345 is defined as Crankshaft Position-Camshaft Position Correlation. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes. Rather, it applies only to specific vehicle makes, such as Audi, GM (Chevrolet/GMC), Isuzu, Lexus, Mazda, Toyota, and Volkswagen.
Where is the camshaft position sensor A located?
The camshaft position sensor can be found in the right side of the engine compartment at the rear of the valve cover.
Where is the crank case sensor located?
The sensor is at either the front or the back of the crankshaft, so it’s usually located either on the transmission bellhousing or behind the crankshaft pulley. There should be a small air gap, usually about a millimeter or two, between the sensor and the reluctor.
How much does it cost to fit a crank sensor?
The replacement cost of the crankshaft position sensor is anywhere from $120 to $300. The cost of the part itself will be around $75 to $120. The cost of the labor will be anywhere from $45 to $180. You need to factor in the estimated taxes and other fees that will be added to the total amount as well.
How much is a crank sensor?
The crankshaft position sensor is a key part of the engine in your vehicle. The average price of a crankshaft position sensor replacement cost is between $194 and $258, with the labor costs estimated between $104 and $133, while the cost of the parts are generally between $90 and $125.
What does p1345 stand for in GM code?
NOTE: Note that code P1345 with the definition “Crankshaft Position (CKP)-Camshaft Position (CMP) Correlation”, is also used by closely related GM products, including Buick, Cadillac, Chevrolet, Isuzu, Pontiac, and Saturn.
What causes a p1345 Chevy to go off the road?
P1345 CHEVROLET Possible Causes 1 Engine mechanical condition-Valve timing off 2 Cam sensor or crank sensor are loose on their mounting 3 Faulty camshaft position sensor 4 Faulty crankshaft position sensor
When to use fault code p1345 in OBD II?
OBD II fault code P1345 is a code used by General Motors – that is defined as “Crankshaft Position (CKP)-Camshaft Position (CMP) Correlation”, and is set when the PCM (Powertrain Control Module) on GM models detects a mismatch (correlation fault) in the input data from the Crankshaft -, and Camshaft Position sensors that exceeds a maximum
What causes p1345 on a camshaft position sensor?
On these applications, excessive wear of the drive gears, or incorrect installation of the distributor are both roughly analogous to defective camshaft position sensors on applications that use distributor-less ignition systems. Nonetheless, some common causes of code P1345 could include the following-